Expert Answers about Buick RV Light Fixtures

• Replacement Lens Recommendation for an RV Patio Light
• This Replacement Lens # OPT47FR is designed to be a replacement lens for the RV Oval Porch and Utility Light # RVPLL11CB or # RVPLL13CB is the light fixture that is on your patio then the # OPT47FR would be the correct replacement lens for you.
  view full answer...


• Replacement Interior LED Lights for 2007 Roadmaster Monaco
• There won't be a way to retrofit old incandescent lights to work with LED lights, so you will need to replace your existing lights. I also am not able to cross reference any of the part numbers you mentioned, but the dimensions are helpful. Something like the Opti-Brite LED RV Dome Light - 880 Lumens - Flange Mount - Rectangle - Clear Lens # ILL10CCB you were looking at might be a good option to replace the larger light since they're similar sizes, but it does not have an exterior switch...
  view full answer...


• Recommended Small Replacement Interior LED Puck Light for an RV
• The GloLight LED RV Dome Light with Chrome Trim Ring # UCL160CB measures 3" in diameter and is a complete light with the lens not being separate, so it's actually going to need to wired into your existing wiring. It sounds like you're looking for a lens instead of a bulb, and the smallest replacement lens we carry is the is 3" in diameter. Since the light you have is a bit small and relatively uncommon, you might find it easier to replace the entire light with the 12V RV Puck Light #...
  view full answer...


• How Many Watts Does the Command Electronics 12V RV LED Puck Light Put Out
• The 12V RV LED Puck Light # 328-K-1050Q9 has a watt output of 3.12 watts.
  view full answer...


• Bulb Type Required for Gustafson RV Pendant Light 277-000416
• Gustafson RV Pendant Light # 277-000416 does not include but accepts a 1076 double-contact bulb. You can use LED element # DI97ZR or # DI47ZR. This efficient LED will provide light with minimal power consumption.
  view full answer...


• Replacement Interior LED Light For Truck Camper On A 2022 Ford F-350
• The Opti-Brite LED Dome Light for Refrigerated Trucks and Trailers # OPT38FR will work fine but it may be quite bright at 1,200 Lumens. Instead, I recommend the Opti-Brite LED RV Dome Light # ILL10CCB, which feature the same dimensions, but only put out 880 Lumens, which will be easier on the eyes.
  view full answer...


• LED Lights or Light Bulbs For RV
• I have attached a list of all of the Rv lighting that include LED lights. Such as Gustafson RV Reading Light Satin Nickel - LED - 3.24 Watt # 277-000334. This light has 3 LED bulbs and is 12V 3.24 Watts. I have also attached a link with all the Rv light bulbs. For example the LED Wedge Base Lamp # DI68VR is 1.8 Watts, 0.15 Amps and has a 50,000 hour life expectancy. LEDs use less power and are more efficient than incandescent lights.
  view full answer...


• Does Gustafson RV Sidewall Light # 277-000254 Come with Base Plate for Wall Fixture
• The Gustafson RV Sidewall Light # 277-000254 that you referenced comes with everything you see in the attached pictures. If you need a base plate you'd have to source that from a local hardware store.
  view full answer...


• Recommendation For Scare Light With Clear Lens For 2013 Keystone Sprinter Travel Trailer
• Yes, we can help. We have an Optronics RV Scare Light, Item # RVSL31, that comes with a clear lens and white metal base. I have attached a link to a review video for you to check out.
  view full answer...


• Parts Needed to Install VueSmart Backup Camera and 3rd Brake Light To Scamp 16 Travel Trailer
• You can fit the Optronics LED Trailer Clearance or Side Marker Light # MCL32RBB to the VueSMART RV and Trailer Backup Camera # HM34FR. The Optronics light has a black base to match the base of the VueSMART camera. Since you are wanting to use the light as a 3rd brake light rather than a running light you will need a 3rd Brake Light Logic Module # PP20-702 to separate the brake light signal from the turn signals on your Scamp 16 trailer. This will require you to run wiring from both tail...
  view full answer...


• Recommended Replacement Interior LED Lights Measuring Over 15
• I did some searching and the closest I was able to find to what you're needing was the: -Optronics 12V LED RV Dome Light # RVILL50 which measures 15-3/4" long, 3-5/16" wide, and is 1-13/16" deep. & -Opti-Brite LED RV Dome Light - 880 Lumens - Flange Mount # ILL10CCB which measures 18" long, 5-3/4" tall, and is 1" thick. The Optronics # RVILL50 has a raw Lumens output of 870, an effective Lumen output of 720 Lumens and the LEDs have a lifetime warranty, while the Opti-Brite LED RV Dome...
  view full answer...


• LED Replacement Light Recommendation For Bargman 68 Round 4-1/2 Inch Trailer Lights
• We have four different round LED stop, turn and tail lights that will fit in the 4-1/2 inch diameter holes in your rear bumper. You could use the Optronics light, # STL23RB, # STL43RB, # STL53RCB or # STL23CCRB. These are 4 inch round lights, but they require a rubber grommet, # A45GB, that allows 4 inch round lights to flush mount in a 4-1/2 inch cutout. Lights # STL43RB and # STL53RCB are sealed, submersible lights if you are adding these lights to a boat trailer. All of these lights...
  view full answer...


• Replacement Pendant Light Glass For A 2014 Bighorn 3685RL
• The closest option I was able to find for your 2014 Bighorn 3685RL is the Gustafson Glass for RV Cylinder Sidewall and Pendant Light # 277-000474, which has a hole diameter of 1-1/4". Since I do not know what your current pendant light looks like, I cannot say for sure that this will match your other lights. The easiest option would be to replace the other lights to match. If you're able to provide a picture or more information about what you have, I can see if we have a suitable replacement...
  view full answer...


• Troubleshooting Why Left Turn Signal Will Not Work On Boat Trailer
• I would first check the bulb of the left tail light and make sure that the socket is not corroded or damaged. You would then have to trace the wire for the fixture looking for any pinched or broken wires. I would also recommended looking for cracked or worn down wires that would allow the copper conductor to come into contact with any metal on your trailer. To make the process easier you could use The Hook Probe Circuit Tester # PTW2993 and start tracing the circuit from the trailer connector,...
  view full answer...


• Replacement 4 Inch Diameter Bedroom Ceiling LED Light
• I recommend checking out the Gustafson RV Puck Light - 4-1/2" - Recessed - 4 Watt # 277-000344 which is an LED ceiling light that is roughly that size at 4-1/2". This is a recessed mounted light that will function on a 12v power feed. If you need a surface mounted light the # 328-K-1050Q9 is also 4-1/2" and would be a nice LED light option. This is a bright, 9 diode LED light that can be operated by an existing switch. If you need a light with a built in switch, we have the slightly larger...
  view full answer...


• Ways to Convert Trailer to LED Type Lighting
• You can convert your RV to separate turn signals and/or LED operation in a couple of ways, depending on how much wiring modification you care to do. Any of your existing lights can be converted to LED operation by swapping out the incandescent bulbs for LED-type replacement elements. We have LED equivalents that are drop-in replacements for many popular standard bulbs. All appear on the linked page and can be selected by bulb number, such as the popular 194 type bulb # A194B that can be...
  view full answer...


• Lighting Options for the Hollywood Racks Sport Rider SE Bike Rack
• I have a solution that would work well with your idea of creating a bracket but no there are no light kits made specifically for the Hollywood Racks Sport Rider SE Bike Rack item # HLY84FR. If you were able to make your tee shaped structure you could attach the Lets Go Aero LED Light Kit for GearCage4 and BigBoss Railed Cargo Carriers item # H01540 lights to it. This kit has stop, turn, and tail light functions. You would just need a 4-flat connector to power the lights. I recommend the...
  view full answer...


• How Does Part A91BOB Mount To The Trailer and Are The Lights It Holds Submersible
• I have a solution for you, but we don't have any clearance lights that would mount with the white bushing you're referring to. If you went with the # AL191AB and # AL191RB like you mentioned you would need the # A91BOB mounting plates to mount them onto your trailer. These can be secure with a nut/bolt or with a self tapping screw into the trailer frame and you can use the same size screw/bolt as the bushings to make sure it's a secure connection. You will also need the 2 Wire Pigtail #...
  view full answer...


• LED Trailer Lights to Replace Bargman # 30-92-002
• The closest LED tail light we carry to Bargman # 30-92-002 that you referenced is part # 328-003-81M1 for the passenger's side and # 328-003-81LM1 for the driver's side. They're fairly close in size but don't have the reverse light circuit like the Bargman lights do.
  view full answer...


• Replacement Lens For Jammy Inc. J-2024 Trailer Light
• I did some research on your Jammy Inc. J-2024 lens and I was able to find the: -Replacement Tail Light Lens for LEDTLK01 Trailer Light Kit # LTL-LENS. This lens is not a direct replacement but we did have a report of a customer who goes on to say it fits perfectly other than the fact that they had to ground down a couple of taps to fit flush with the fixture. As we do not carry a direct replacement this is going to be the best option for you.
  view full answer...